User Tools

Site Tools


Sidebar


Product Index


i13 Drawbridge

Click for original

Product Name: i13 Drawbridge
Product ID: 21538
Published Artist(s): Daz Originals
Created By: ironman13
Release Date: 2015-06-05

Product Information

  • Required Products: None

Exciting new drawbridge environment for both DAZ Studio and Poser!

Product Notes

Installation Packages

Below is a list of the installation package types provided by this product. The name of each package contains a Package Qualifier, which is used as a key to indicate something about the contents of that package.

  • [1 DS]
  • [1 Ps]

[ ] = Optional, depending on target application(s)

Not all installation packages provide files that are displayed to the user within the interface of an application. The packages listed below, do. The application(s), and the location(s) within each application, are shown below.

i13 Drawbridge DS

  • You can find new icons for loading this product in the following DAZ Studio Folders:
    • “Environments:Architecture:Drawbridge”
    • “Environments:Architecture:Drawbridge:Cameras”
    • “Environments:Architecture:Drawbridge:Lights”
    • “Environments:Architecture:Drawbridge:Props”
  • You can find new icons for this product in the following DAZ Studio Categories:
    • “Cameras”
    • “Environments:Architecture:Exterior”
    • “Lights:Exterior”
    • “Props:Architecture”
    • “Props:Landscape”

i13 Drawbridge Ps

  • You can find new icons for loading this product in the following Poser Libraries:
    • Camera: “Drawbridge”
    • Light: “Drawbridge”
    • Props: “Drawbridge”

Additional Details

  • When raising and lowering the drawbridge, you can also adjust the angle of the drawbridge chains so that they fit inside the castle holes. Select the drawbridge chains and in the Parameters tab, use the dial labelled “adjust chain angle”
  • To open doors, select the door you would like to open, in the Parameters tab you will see a dial that reads “open”. If you need the doors to open further, or you want to reposition them and make them open the other way, you'll need to take the limits off by clicking on the gear on the “open” parameter, on the lower right of the dialogue, uncheck “Use Limits”.
  • The portcullis (the iron gate piece that's in front of the doors) raises and lowers, when raised all the way up it pokes through the top of the castle a bit, there is a morph to collapse the top of the portcullis. You can get to it from the Parameters tab under Morphs, or from the Shaping tab while selected on the portcullis.

Resolved Issues

  • None

Known Issues

  • None

Support

Visit our site for technical support questions or concerns.