User Tools

Site Tools


This page exists within the Old ArtZone Wiki section of this site. Read the information presented on the linked page to better understand the significance of this fact.

Using Dynamic Settings

Once the dynamic LOD settings have been set using the Dynamic LOD Settings panel, the settings can be activated in the Parameters tab.

  1. Select Use Dynamic Settings from the LOD Settings menu to activate the dynamic settings of the LOD figure.
  2. As you work with the figure, the settings will be applied based on the options you chose.

Examples:

  1. Simple LOD was selected with a viewport level of 2K and render level of Base. While working in the viewport, the 2K mesh is used but when Render is selected, the high-res Base mesh is used.

    lodsimple.jpg
  2. Advanced LOD was selected with the settings shown below. While working in the viewport and moving the camera, the specified LOD level is automatically switched to when the object goes beyond the specified range from the camera. loddistance.jpg